Experiment 1:
Calibration of load cell using standard weights.
Watch here
Experiment 2:
Calibration of LVDT using micrometer.
Watch here
Experiment 3:
Calibration of micrometer using slip gauge.
Watch here
Experiment 4:
Measurement of Taper angle using sine bar and slip gauge.
Watch here
Experiment 5:
Measurement of surface roughness of a component using mechanical comparator.
Watch here
Experiment 6:
Measurement of a screw thread parameters using floating
carriage micrometer by 2-wiremethod.
Watch here
Experiment 7:
Measurement of gear parameters using gear tooth vernier.
Watch here
Experiment 8:
Measurement of alignment of surface plate using roller set.
Watch here
Experiment 9:
Comparison and measurement of temperature using
thermocouple and RTD.
Watch here
Experiment 10:
Measurement of cutting forces and torque using lathe/ drill
tool Dynamometer.
Watch here
Experiment 11:
Determination of young s modulus using strain gauge.
Watch here